My press is a Lee Pro 1000.
I have heard many criticisms about it by my fellow fans. It 's true, is not automatic, sometimes it is blasphemy because the first car (the saucer that automates the routing and placement of the triggers), which is sometimes "jump" the trigger (and encapsulated wrong) due to dirt or a bit of dust; avereun should focus on when you manually insert the ball, but keep in mind that it was a gift (a good start saving, thanks again Mark!) and I think is great for beginners. The care and attention it demands this press combined with the simplicity of the mechanics and low cost, in my opinion is a very good product for giovanericaricatore.
E'formata of: base Turret, Shell plate cal. 9 (the "saucer", which encompasses the bottom and
accompanies the cartridge case in the different phases up to the manufacture of the projectile), the expanding
dies (this is the 1st stage of the press: the flaring mouth of the cartridge case with a steel needle and pushes out the primer used), the first car (see above) The dispenser of powder dispenser complete with micrometer (apart from the microdisks) and crimp dies (the last stage, in which the ball rests in the invitation of the cartridge case flared after the ball is pressed into the cartridge case, and the cartridge case is "choked" to remove the flare.
three stages: extraction and trigger flare cartridge case, primer and inserting new release
powder, ball and crimping support. Simple as it seems. actually CARE
MUST NEVER BE LESS DURING THE OPERATION OF CHARGE! . NEVER think that you have achieved a degree of security, and speed up the pace to get up / down lever.
We have 2 eyes and 3 stages to follow, always be careful!
the results could be disastrous!
0 comments:
Post a Comment