The press (Turret) has a medium-like a triangle, whose base measures 10cm hypothetical side sloping sides and 8.5 cm.
I've got a table (thanks again to Mark!) Iron 65x43 plywood floor with sturdy 3-inch thick (it should withstand tensile forces over time). Of course the press should be put behind the plan, making sure to leave room (in my case) 3 mm from the edge plan, so that the key can get up and fall without frictions and obstacles. The most difficult part in the installation was the exact length of the call chain that prevents the escape of dust.
Each stage should be tried, we must be sure of the success of our cartridge.
The stage 1 works as follows: in the first round of military (I mean the movement get up / down with made in full), cases with the bottom face is pushed down and made "hug" from the shell plate (a disc that has 3 notches on the ends of the same width of the bottom), the second round of the cartridge case lever is made up nell'expanding dies, thanks to the stem metal within it the old trigger is pulled, and the mouth of the cartridge case is flared (enlarged in the total circumference) and in lowering the lever, the shell plate rotates to the second stage.
In the 2nd stage of our military around the cartridge case is triggered (just push the lever forward to raise a little support on which rests the trigger again, brought it through the plate to engage (first car), when raise the lever triggered the cartridge case is made up, goes inside the "channel" of the dispenser, which releases it by raising the amount of powder desired. Here, too, while lowering the plate around and brings us to the 3rd stage.
In it must manually place the ball on the flared mouth of the cartridge case, and lifting the ball will enter the cartridge case, and it will be "choked" to eliminate the flare. Lowering the lever, and completing our fourth lap leverage the bullet will be directed towards a canal on the left and we will have our first shot to be fired.
We take into account that in the meantime we have completed this, we prepared three shell casings on the 3 areas of the plate, because at each turn of leverage, there is an advance stage.
0 comments:
Post a Comment